Yukon Gear & Axle Adapter Sleeve For GM 11.5" & 10.5" 14 Bolt Truck Yokes To Use Triple Lip Pinion Seal

I had an old pinion to install on a newer housing with the triple lip seal. This fit the old pinion yoke and installed without a problem.

I had a pinion leak on my 2008 Dodge 2500 and this was a perfect fit. I think Amazon needs to update their information for "It will fit!" Good quality and easy to install.

This is the seal behind yoke (which rarely fails). Yukon part # YMS2286 is pinion seal.

Worked perfectly

Works great no leaks

Fit my 2006 Duramax with AAM 11.5 diff, this is the pinion yoke seal/wear sleeve you need to replace when replacing the pinion seal on the diff, you can remove this seal with a pry bars and working your way around the seal to pop it off the yoke, I applied a thin layer of RTV to the yoke and tapped the seal on using a wood block and dead blow mallet until it was fully seated.

How to replace:Thread in two of the bolts and lock the yoke in a vise catching the bolt heads with seal up.Use two large screw drivers opposite each other to pry the seal sleeve up equally at both sides. It will be easier than expected. The seal has lived a life soaked in gear oil.Clean the land area with carb cleaner and a rag. Carb cleaner will help get residual ribber off.Then use scotch bright to get all of the old residual rubber off from old sleeve land.Find a firm cup that fits inside the sleeve to push it on.Lube the land and inside the seal very lightly with liquid soap.The seal will push on really easy. No hammer, just firm push. You may not need the cup.Put grease lightly on all three rubber seal friction surfaces; dry assembly is not good here.Put teflon thread sealer on the splines or they will leak.Fits 2006 Ram 2500 AAM axle

Does not work on a 2013 ram 2500. It will fit but not seal.