ELEGOO 8K Water Washable Resin, Higher Precision 3D Printer Resin, 405nm Rapid UV Curing Photopolymer Resin, 3D Resin for LCD/MSLA/DLP 3D Printer Printing, 8K Space Grey 1000GCarbonfree Certified

These resins have beautiful color to them and look good solid or hollow, though the solid models do look better. I've printed in the smokey black, green, and blue colors and I'm very happy with all of them!The water-washable aspect has completely changed my printing habits. Using IPA in the past was a major headache and annoyance. With the water-washable, I can simply put about a gallon of hot water in a tub and use a toothbrush to clean up the miniatures. Rinse them off in another small tub of cool water, then place in front of a fan to dry off before curing. The used water can then be left outside in the sun for a few hours to cure the washed-off resin. Strain the water and toss the cured resin. Easy peasy and no spending $$$ on IPA and dealing with fumes, storage, etc.

Overall I would have to say I liked this product. It shows wonderful details in the finished product, easily washes off under water, and has a is low odor when printing. The viscosity is great and I had no problems on models I vented and supported properly. The only downside I have found is that it is a very brittle product once cured. Small pieces can easily snap off. When used for printing miniatures (my primary use) the smaller details are often the most crucial.

Don't let the picture deceive you. I wanted to post it to warn people that it might happen, but also wanted to sing the praises of the product. This is the second bottle of the Clear Red resin I have purchased, and it is an excellent resin. It has a slightly stronger odor than the Solid Gray resin of the same type, but the prints come out beautifully.My second bottle arrived damaged. However, thanks to the packaging it arrived in, the liquid was all contained inside an air-tight bag, and funneling it into my old bottle was a piece of cake.The bottle could possibly use a bit of reinforcement on the lid to prevent this in the future, as it seems that section of the lid may be a weak point in the construction.Included is a picture of some minis that I've printed to show off the clarity of the resin. These were printed on the Elegoo Mars 2 Pro. (Camera's not stupendous, though)TLDR - Product is excellent, moderate odor, good clarity after printing. Bottle has a glaring weak-point, but packaging around it is air-tight baggy, so no problem.

I own a new Elegoo Saturn IV ultra, and am using this product to make miniatures for a new game I designed.... Made over 1000 pieces in just a few days, and only had 1 bad batch.... the pieces are strong and durable, washed and cured each for 2 1/2 minutes on both processes per batch of 15-28 pieces and the detail is great.....

This resin is beautiful. I love the color, but his has a more potent smell than Anycubic. I printed some coasters with it and they look great except for the outer edges. I washed them for 6 minutes and they still had resin around the edges. I scrapped it off and washed for another 6 minutes. They still had some resin. I just decided to cure them, sand them, and spray with a gloss finish. I have not had this problem with anycubic resin. Maybe I did not shake the resin enough.

Excelente producto

I highly recommend this resin

Excellent resin. It has a slightly strong odor, but the prints come out beautifully.