💪 Power Meets Precision in Every Drop!
The AMT Pump 5390-95 is a high-performance immersion coolant pump designed for machine tools. With a robust 1/4 HP motor, it efficiently pumps fluids as shallow as 2 inches, featuring a durable cast iron body and a stainless steel impeller. Its innovative sealless design allows for the safe handling of abrasives, making it an essential tool for any professional workshop.
R**R
Wiring diagram is wrong
Until they change the wiring diagram ,when you open the cover you will find 2 pair of wires each connected with a screw. for 110volts just take an extension cord with Black Green and White and place black on one side and white to the other screw. Of course, green goes to a ground and just make sure when you plug it in that the pump is rotating in the right direction, and if not just switch the wires.
L**.
Works great on our 220 volt madison grinder from the 40s.
Not super strong but more than adequate. Added some risers and looks like this thing will last some time. Very happy with it.
L**E
great pump
Quiet, affordable, well built.. Only the mismarked label for wires, cover off, clear which wires go where.I am Very happy with pump.
M**J
Great replacement for our mitsubishi pump at a fraction of the cost
We had an old Mitsubishi pump that went out on our Mazak CNC Lathe. This one was the same size and amperage as the Mitsubishi. It came in next day and we were back up an running in an hour after it was delivered and saved several hundred dollars. Would recommend it.
K**Z
Looks very well constructed. Used on my Acra 1340G Lathe. Wiring is confusing
This is a nice pump, well constructed. Mine came pre-wired for 110v. The wiring diagram sticker on the outside of the motor is confusing because the actual wires are labeled/numbered differently than the wire numbers on the pump housing wire grommet (which is what you should follow for changing voltage setups). The wire diagram on the outside of the pump follows the numbers (hard to see visually) that are on the molded rubber grommet where the wires protrude from inside the motor. Ignore the wire numbers on the actual wires (this is poor execution of information, very misleading). I would switch the wire labels to letters so that there is less confusion or use the wire colors for instructions on which to connect for different voltages.
J**.
awsome
Easy to wire for 230v ac and grate volume per minute. Perfect for my surface grinder coolant system.
C**S
Wiring mislabeled
Fits my Arca bandsaw like the original. However, and potentially dangerous, the wiring isn't labeled correctly. The diagram on the outside states to use wires 1, 3, 5, & 6. Open the cover to find wires 1, 2, 3, & 4.
Trustpilot
2 weeks ago
2 months ago
