Klein Tools32216 #2 Phillips Screw Holding Screwdriver, 7-Inch Round Shank

When you need one hand for balance (as when you must reach overhead while standing on a ladder) a good, long screwholding screwdriver can make your task much safer and easier. This tool is well designed and certainly worth the money.

Nice soft handle and I don't drop screws anymore. It's a good tool.

Works just fine.

It held the screws very well. Designed so the it will not drop or stop holding screws. Now ig the head of screw is small then the screw may not be held but the screw itself would have to be quite small.

This tool working great on hot panel take out and installed breaker bolt in . Buy one

I had a Craftsman for an 40 years and mine broke about 5 years ago and finally replaced with this and I actually like it better. Holds screws great

This device towers above every silly, derivative and gratuitous novelty being peddled by aspiring entrepreneurs on "Shark Tank," where the message is: To the Energy Bunny goes the gig (with Mark, if you're lucky). I expected another screwdriver with a magnetic tip barely holding a screw straight enough and long enough to be effective without an electric drill. Much to my surprise, this invention ("gadget" is too frivolous a word for a tool as practical as this) is better than a 2nd human helper (even one willing to withstand multiple blows to the fingers)!An ingenious spring works in combination with the tool's slotted holder to enable precision alignment of your screw followed by near-permanent attachment between the driver and the screw--from starting the screw-hole to finishing the job. The Klein Phillips screwdriver is with you every millimeter and millisecond of the way.Just a couple of cautions: 1. The size of the screw head is everything. Make sure it's a "wood screw" with a head that's sufficiently wide and deep (the tiny area that fans out from the screw to the underside of the head). If it's the wrong size, you should know immediately, as it won't earn a solo spot at the screwing end of the device. (I had some "ringers" that were instantly expelled.). 2. Don't get "vicious" about turning the driver until it absolutely will not budge. The driver has a clever "safety" that should prevent you from "over-screwing." Try to be good with "tight": no need to exhaust all your "might." Don't push it. It knows what it's doing.I bought my first iPod in 2002. I wish I could say this intelligent screwdriver is the best invention since the iPhone (2008), but sadly (for me) a device that tries to be a phone in addition to an iPod, a quality camera, an audio-video recorder, a GPS, a movie theater, and a computer amounts to one confusing (not to mention confused) telephone. Oscar goes to Klein Tools.

I wanted this for “Spax #2” flat head and it will not hold it

Muy útil

I fitted an overhead door closer the other day and while screwing the arm to the bracket on the frame I had several attempts at starting the screw one handed while tensioning the arm over into position. using a magnetic bit holder did work but it took 4 or 5 goes at it, with some choice language. I saw this screwdriver online and ordered it as it was reasonably priced. it does the job beautifully . the screw is held solidly, you can not shake it off. I also use it when refitting Upvc sashes, another frustrating job. so yeah another handy little tool to have in your tool bag.

It will be good for large household screws.

Works very well to remove flathead screws in the back of panels where dropping a screw can be problematic.

This is well made and it works